So, with the team's third Top 10 finish, I realized we needed a trophy case.
This is going to hang on the wall in our office. Exact dimensions are to be determined later, and we'd add some LED strips facing towards the back of the case to show the trophies off.
Anyone have any suggestions on stuff that might need to be changed? We have a couple other smaller trophies that will likely go in here, and one Top 3 trophy from our Baja days (which is huge) which may or may not end up in there
Grey pieces are a foam core, we'll do a carbon fiber interior and exterior, then machine some corner mounts and find some aluminum C-channels for the front. I'll likely laser cut some design for the front like I did for my speedo cover.
This is going to hang on the wall in our office. Exact dimensions are to be determined later, and we'd add some LED strips facing towards the back of the case to show the trophies off.
Anyone have any suggestions on stuff that might need to be changed? We have a couple other smaller trophies that will likely go in here, and one Top 3 trophy from our Baja days (which is huge) which may or may not end up in there
Grey pieces are a foam core, we'll do a carbon fiber interior and exterior, then machine some corner mounts and find some aluminum C-channels for the front. I'll likely laser cut some design for the front like I did for my speedo cover.