I was shitting myself for a week
I can only drop a load per day at the dump.
Is it possible to 3D print a gasket?Disassembled, cleaned and reassembled the carb on the generator. The guts in it were pretty sticky.
Flushed fresh gas through it, almost started on the 1st pull, started on the 2nd. Woohoo!
Used all the old gaskets. I don't even think I can get a carb rebuild kit for this thing. No idea who makes this engine.
Yes. I've seen it done in TPU.Is it possible to 3D print a gasket?
You can, but I'd sooner just buy a sheet of bare gasket and cut it with an xacto knife.Is it possible to 3D print a gasket?
That stuff's good right up to the point you get some idiot smearing it on like peanut butter and then it ends up blocking coolant passages after it breaks off.
That stuff's good right up to the point you get some idiot smearing it on like peanut butter and then it ends up blocking coolant passages after it breaks off.
That's the unspoken advantage of miata ownership. Find a closeted mechanic to barter with and you don't have to worry about that stuff.I doubt @Mikeawesome even knows how to use a wrench well enough to even get to that point.
You can, but I'd sooner just buy a sheet of bare gasket and cut it with an xacto knife.
Friend's tech shop has a laser cutter if it ever came to that. For a crappy carburetor gasket, knife and sheet is easy.
Powered stencil cutter if you do it alot or they're huge. $150. Scan, run through software, cut.
Ouch.first time ever i had kickback on the tablesaw.
Was cutting the back off an outlet box to make a quick LV old work box, Table saw flung the cutoff at me, bounced off my hand gouging up my thumb and then hit me square in the mouth.
Glad it was a hollow piece of plastic and not a piece of wood or else i might have a broken thumb and some busted teeth.
first time ever i had kickback on the tablesaw.
Was cutting the back off an outlet box to make a quick LV old work box, Table saw flung the cutoff at me, bounced off my hand gouging up my thumb and then hit me square in the mouth.
Glad it was a hollow piece of plastic and not a piece of wood or else i might have a broken thumb and some busted teeth.
Always do. Had my eyepro on, but i should wear my full mask. It was raining and it kept fogging up :/Gotta respect that saw, man, itll fuck you up quick
first time ever i had kickback on the tablesaw.
Was cutting the back off an outlet box to make a quick LV old work box, Table saw flung the cutoff at me, bounced off my hand gouging up my thumb and then hit me square in the mouth.
Glad it was a hollow piece of plastic and not a piece of wood or else i might have a broken thumb and some busted teeth.