Hawt The Blatantly Misogynistic Man Thread

I maed a simple bench, with plenty of room to put your beer.

TsuQ2v0.png

Did you use plans or just free ball it?
 
Snowblower adventures continue.

Electrolytic rust removal kicks ass. These augers looked like the shave plate I've got them hung from when I first started. Wire wheeled them, did 12 hours of electrolysis, wire wheeled them again and they're going in for a second round.

20201122_182414.jpg

Other two augers are already done, using the same method. Got the etch primer mostly cleaned off the old housing and they're now primed using proper primer.

20201122_182719.jpg
 
  • Gravy
Reactions: wetwillie
If you dig into them a bit, the outer edges of the board were less accurate due to trig issues at the far ends, but being that it is open source I think that's been solved by now.
There is an upgraded kit.